Back to Blog
How-to Guides 2026-11-22 ACUITY Instruments: Performance Automotive Products 0 views

Throttle Body Coupler for 1891 Cold Air Intake: Replacement Guide

Throttle Body Coupler for 1891 Cold Air Intake: Replacement Guide

Replace the throttle body coupler on your ACUITY Curl Control intake to fit an OEM manifold or ZDX throttle body. Step-by-step guide with compatibility and installation tips.

What This Coupler Does

The ACUITY Throttle Body Coupler for the 1891 Curl Control Cold Air Intake System lets you adapt the intake to work with an OEM intake manifold and a larger throttle body, such as the Acura ZDX unit or similarly sized aftermarket throttle bodies. It is the same coupler supplied in the full Curl Control kits, sold separately for those who already own the intake and want to change their setup.

Coupler Details at a Glance

Installation Steps

These steps assume you already have the ACUITY Curl Control intake installed and are swapping the coupler to adapt to a different throttle body or manifold. Always work on a cool engine and disconnect the battery negative terminal before starting.

  1. Remove the existing intake piping: Loosen the clamps on the current coupler at the throttle body and the carbon tube or velocity stack. Carefully pull the intake tube free and set it aside.
  2. Remove the old coupler: Slide the old coupler off the throttle body and manifold openings. Inspect the mating surfaces for debris or old gasket material.
  3. Install the new coupler: Slide the ACUITY 1891-C2 coupler onto the throttle body first, then onto the OEM intake manifold. Ensure the integral aluminum barb is oriented to connect the valve cover breather hose. The coupler has reliefs designed for a smoother air transition—align them as needed.
  4. Secure the coupler: Tighten the clamps evenly. Do not overtighten; the silicone should compress slightly but not distort.
  5. Reattach the intake tube: Connect the carbon tube or velocity stack to the other end of the coupler and tighten the clamp. Reconnect the valve cover breather hose to the aluminum barb.
  6. Reconnect battery and check for leaks: Reconnect the battery, start the engine, and let it idle. Listen for any hissing or vacuum leaks. If the idle is stable, the installation is complete.

Compatibility Notes

This coupler is specifically designed for 2012–2015 Honda Civic Si models with the original intake manifold, a ZDX or similar big-bore throttle body, and the ACUITY Curl Control cold air intake. It is not a universal part—verify your existing setup matches these components before purchasing. The coupler does not include clamps or breather hose; reuse your existing hardware or purchase separately.

Trade-Offs to Consider

Switching to this coupler allows you to keep your Curl Control intake when upgrading to a larger throttle body, saving the cost of a complete new intake. However, the installation requires access to the throttle body area, which may be tight on some vehicles. The coupler’s rigid silicone construction provides excellent durability but may require careful alignment to avoid binding against the engine bay components.

Related Articles

Customer Service
Home
Products
Cart
Profile